Fujitsu PRIMERGY RX2540 M4 Upgrade And Maintenance Manual page 565

Indication of LAN connection supporting Energy Efficient Ethernet
(EEE mode)
To configure the EEE mode, it is necessary that the on board LAN or an add in
LAN card supports this mode and the connected switch supports this mode as
well.
Pos. Indicator
1 LAN
link/transfer
indicator
2 LAN speed
indicator
Table 3: LAN indicators if EEE mode is active
I
Note on the onboard LAN controller
The system board is equipped with a Gigabit Ethernet Controller that
supports transfer rates of 10 Mbit/s, 100 Mbit/s and 1 Gbit/s.
The separate management LAN connector is used as a management
interface (iRMC S4) and is prepared for operation with the Remote
Management. Optionally LAN connector 1 can also be used for iRMC S4
server management.
RX2540 M4
Status Description
short flashing A LAN connection has been established
green 3x, (1 Gbit or 100 Mbit) and EEE mode is
then off active
short flashing Data traffic at a transfer rate of 1 Gbit/s.
yellow 1x,
then
2 seconds off
green off
short flashing Data traffic at a transfer rate of
green 1x, 100 Mbit/s
then
2 seconds off
yellow off
Upgrade and Maintenance Manual
Appendix A
565