Concluding Steps; Removing A Psu; Preliminary Steps; Note For Servers Using Cma (Cable Management Arm) - Fujitsu PRIMERGY RX2520 M4 Upgrade And Maintenance Manual

Power supply unit (PSU)
Figure 23: Installing the cable tie
Ê Push the cable tie into the corresponding hole until it clicks in.
6.2.1.4

Concluding steps

"Connecting the power cord" on page 59
Ê
Ê If applicable, configure the redundant power supply.
"Performing a fan test" on page 96
Ê
6.2.2

Removing a PSU

Customer Replaceable Unit
(CRU)
Tools: tool-less
6.2.2.1

Preliminary steps

Ê Only when replacing a PSU in a non-redundant configuration:
down the server" on page 48
6.2.2.2

Note for servers using CMA (Cable Management Arm)

Regarding of removing PSUs, additional tasks are needed, due to an
interference between CMA stopper and the PSUs.
104 Upgrade and Maintenance Manual
Hardware: 5 minutes
"Shutting
RX2520 M4