Installing An Expansion Card In A Riser Module; Remove The Slot Cover For The Riser Module 1; Remove The Rear Air Grid Riser Module 1 - Fujitsu PRIMERGY RX2540 M4 Upgrade And Maintenance Manual

9.9.1.2

Installing an expansion card in a riser module

Ê If applicable, remove the slot cover from the riser card holder, see section
"Removing the slot cover" on page
Figure 189: Installing an expansion card in a riser module
Ê Carefully insert the expansion card into the desired PCI slot and press down
firmly until it is fully seated in the slot.
Ê Fasten the expansion card with the screw (see circle).
9.9.1.3

Remove the slot cover for the riser module 1

Ê Remove the slot cover for the riser module 1, see section
cover for the riser module 1" on page
9.9.1.4

Remove the rear air grid riser module 1

Ê Remove the rear air grid riser module 1, see section
grid riser module 1" on page
RX2540 M4
269.
274.
Upgrade and Maintenance Manual
Expansion cards and backup units
271.
"Removing the rear air
"Removing the slot
281