Installing The New Riser Card; Connecting Cables To The Expansion Card; Connecting A Fbu To The Expansion Card; Concluding Steps - Fujitsu PRIMERGY RX2540 M4 Upgrade And Maintenance Manual

Expansion cards and backup units
9.9.6.3

Installing the new riser card

Ê Install the new riser card, see section
Ê Install the expansion card, see section
riser module" on page
Ê If applicable, install the riser module 1, see section
module 1 (HL)" on page
Ê If applicable, install the riser module 2, see section
module 2 (HL)" on page
9.9.6.4

Connecting cables to the expansion card

Ê If applicable, connect internal cables to the expansion card.
I
For the cable plan, see chapter
9.9.6.5

Connecting a FBU to the expansion card

Ê If applicable, connect an FBU cable to the expansion card, see section
"Installing the new TFM" on page
9.9.6.6

Concluding steps

"Reassembling" on page 63
Ê
Ê Connect all external cables to the replaced expansion cards.
"Connecting the power cord" on page 67
Ê
"Switching on the server" on page 70
Ê
"Enabling replaced components in the BIOS" on page 108
Ê
Ê If applicable,"Updating expansion card firmware" on page
"Resuming BitLocker functionality" on page 112
Ê
9.10

GPGPU cards in riser modules (FL)

I
FL means cards with full length (312 mm).
290
281.
75.
79.
311.
Upgrade and Maintenance Manual
"Installing the riser card" on page
"Installing an expansion card in a
"Installing the riser
"Installing the riser
"Appendix B" on page
73.
573.
100.
RX2540 M4