Installing The Controller - Fujitsu PRIMERGY RX2540 M4 Upgrade And Maintenance Manual

Hard disk drives (HDD) and solid state drives (SSD)
Figure 122: Connecting cables to the 2.5-inch PCIe SSD backplane
Ê Connect the following cables:
– The power cable (1) from the PCIe SSD backplane to the system board
connector "PWR2" (for the first PCIe SSD backplane) or "PWR3" (for the
second PCIe SSD backplane).
– The color-coded Oculink cables (2) to the PCIe SSD backplane:
Color
red
yellow
green
black
– If applicable, the OOB cable (3) from the PCIe SSD backplane to the
system board connector "OOB Front".

7.4.12.4 Installing the controller

Ê If applicable, install the controller, see section
on page 253.
7.4.12.5 Installing additional PCIe SSD modules
Ê Remove the dummy locks, see section
module" on page
Ê Insert additional PCIe SSDs, see section
module" on page
208
Connector on PCIe SSD backplane
182.
183.
Upgrade and Maintenance Manual
a
"P0_X1"
"P1_X2"
"P2_X3"
"P3_X4"
"Installing an expansion card"
"Removing a 2.5-inch dummy
"Installing a 2.5-inch HDD/SSD
RX2540 M4