Preliminary Steps; Removing An Expansion Card; Installing An Expansion Card - Fujitsu PRIMERGY RX2540 M4 Upgrade And Maintenance Manual

Expansion cards and backup units
Note on network settings recovery
I
When replacing network controllers or the system board, network
configuration settings in the operating system will be lost and replaced
by default values. This applies to all static IP address and LAN teaming
configurations.
Ensure to note down your current network settings before replacing a
controller or the system board.
9.5.3.1

Preliminary steps

Ê If applicable, "Note on network settings recovery" on page 266
"Locating the defective server" on page 53
Ê
"Suspending BitLocker functionality" on page 91
Ê
"Shutting down the server" on page 55
Ê
"Disconnecting the power cord" on page 56
Ê
Ê Remove all external cables from the expansion card to be replaced.
"Getting access to the component" on page 58
Ê
Ê Locate the defective expansion card using the onboard Local Diagnostic
LEDs, see section
9.5.3.2

Removing an expansion card

Ê If applicable, "Removing an SFP+ transceiver module" on page
"Removing an expansion card" on page 263
Ê
Ê If the slot bracket on the defective expansion card is to be reused, remove it
from the board, see section
9.5.3.3

Installing an expansion card

Ê If applicable, "Installing a slot bracket" on page
"Installing an expansion card" on page
Ê
Ê If applicable, "Installing SFP+ transceiver modules" on page
266
"Onboard indicators and controls" on page
"Removing a slot bracket" on page
Upgrade and Maintenance Manual
239.
254.
551.
244.
240.
241.
RX2540 M4