Replacing Gpgpu Cards In Riser Modules - Fujitsu PRIMERGY RX2540 M4 Upgrade And Maintenance Manual

9.10.5 Replacing GPGPU cards in riser modules

Upgrade and Repair Unit
(URU)
Tools: Phillips PH2 / (+) No. 2 screw driver / hexagon screw driver 5 mm
9.10.5.1 Preliminary steps
Ê If applicable, "Note on network settings recovery" on page
"Suspending BitLocker functionality" on page 91
Ê
"Locating the defective server" on page 53
Ê
"Shutting down the server" on page 55
Ê
"Disconnecting the power cord" on page 56
Ê
"Getting access to the component" on page 58
Ê
Ê If applicable, disconnect internal cables from the GPGPU card.
Ê Locate the defective GPGPU card using the onboard Local Diagnostic
LEDs, see section
9.10.5.2 Removing the defective GPGPU card
Ê If applicable, remove the riser module 1, see section
module 1 (FL)" on page
Ê If applicable, remove the riser module 2, see section
module 2 (FL)" on page
Ê Remove the GPGPU card, see section
page 298.
9.10.5.3 Installing the new GPGPU card
Ê Install the new GPGPU card, see section
module" on page
Ê If applicable, install the riser module 1, see section
module 1 (FL)" on page
RX2540 M4
"Onboard indicators and controls" on page
82.
85.
291.
83.
Upgrade and Maintenance Manual
Expansion cards and backup units
Hardware: 10 minutes
Software: 5 minutes
"Removing the riser
"Removing the riser
"Removing a GPGPU card (FL)" on
"Installing a GPGPU card in a riser
"Installing the riser
266.
551.
305