Disconnecting The First 3.5-Inch Hdd Backplane - Fujitsu PRIMERGY RX2540 M4 Upgrade And Maintenance Manual

"Getting access to the component" on page 58
Ê
Ê Release all HDD modules and pull them out a few centimeters, see section
"Removing 3.5-inch HDD modules" on page
I
The HDD modules need not to be removed. But if you want to remove
them nevertheless, check if all HDD/SSD modules are uniquely
identified so that you can reinsert them into their original bays.
Ê Release all dummy modules and pull them out a few centimeters, see
section "Removing a 3.5-inch dummy module" on page
"Removing the fan holder" on page 233
Ê
7.3.8.2

Disconnecting the first 3.5-inch HDD backplane

Figure 62: Disconnecting cables from the first 3.5-inch HDD backplane
Ê Disconnect the following cables from the HDD backplane:
1 Power cable
2 SA/SATA cable
3 If applicable, OOB cable
4 If applicable, ODD power cable
Ê Remove the three screws (see circles).
I
For the first time remove a fourth screw on the lower edge of the HDD
backplane. This screw is only used as a transportation lock.
RX2540 M4
Hard disk drives (HDD) and solid state drives (SSD)
Upgrade and Maintenance Manual
151.
148.
155