Installing The Ocp Module; Concluding Steps - Fujitsu PRIMERGY RX2540 M4 Upgrade And Maintenance Manual

9.4.1.3

Installing the OCP module

Figure 161: Installing the OCP module
Ê Install the OCP module with the bottom side above (1) on the four bolts (see
figure 158). Ensure that the connectors are positioned correctly in the rear
side.
Ê Fasten OCP module with four screws (part of OCP kit) on the four bolts (2).
9.4.1.4

Concluding steps

Ê If applicable, install the riser module 1, see section
on page 71.
"Reassembling" on page 63
Ê
"Connecting the power cord" on page 67
Ê
"Switching on the server" on page 70
Ê
Ê Inform the customer about changed WWN and MAC addresses. For more
information, see section
addresses" on page
"Updating the NIC configuration file in a Linux and VMware environment" on
Ê
page 112
"Configuring LAN teaming" on page 119
Ê
RX2540 M4
"Looking for MAC/WWN/GUID and SAS
115.
Upgrade and Maintenance Manual
Expansion cards and backup units
"Handling riser modules"
249