Removing A Memory Module - Fujitsu PRIMERGY RX2540 M4 Upgrade And Maintenance Manual

12.4.2.2 Removing a memory module

Ê Pull up the required memory cover(s), see figure
Ê Open the required memory cooling unit, see figure
– Swing the left/right memory cooling unit(s) in the direction of the pump
(see arrows).
– Swing the central memory cooling unit in the direction of the arrow.
Ê If applicable, remove the memory spacers.
Ê Remove the memory module, see section
page 341.
Ê If applicable, install the memory spacers, see section
spacer" on page
Ê Close the required memory cooling unit(s).
Ê Position the memory cover(s) over the memory modules and press them
carefully down, see figure
12.4.2.3 Concluding steps
Ê If applicable, install the riser module, see section
cards (FL)" on page
"Reassembling" on page 63
Ê
"Connecting the power cord" on page 67
Ê
"Switching on the server" on page 70
Ê
"Resuming BitLocker functionality" on page 112
Ê
12.4.3 Replacing memory modules
Upgrade and Repair Unit
(URU)
Tools: Phillips PH2 / (+) No. 2 screw driver (for the riser module)
RX2540 M4
389.
261 on page
82.
Upgrade and Maintenance Manual
Liquid cooling (LC)
249 on page
267 on page
"Removing a memory module" on
"Installing a memory
379.
"Riser modules for GPGPU
Hardware: 5 minutes
370.
385.
387