Preliminary Steps; Removing The Defective Expansion Card - Fujitsu PRIMERGY RX2540 M4 Upgrade And Maintenance Manual

Tools: Phillips PZ2 / (+) No. 2 screw driver / hexagon screw driver 5 mm
Note on network settings recovery
I
When replacing network controllers or the system board, network
configuration settings in the operating system will be lost and replaced
by default values. This applies to all static IP address and LAN teaming
configurations.
Ensure to note down your current network settings before replacing a
controller or the system board.
9.9.5.1

Preliminary steps

Ê If applicable, "Note on network settings recovery" on page 266
"Suspending BitLocker functionality" on page 91
Ê
"Locating the defective server" on page 53
Ê
"Shutting down the server" on page 55
Ê
"Disconnecting the power cord" on page 56
Ê
Ê Remove all external cables from the expansion card to be replaced.
"Getting access to the component" on page 58
Ê
Ê If applicable, disconnect internal cables from the expansion card.
Ê Locate the defective expansion card using the onboard Local Diagnostic
LEDs, see section
9.9.5.2

Removing the defective expansion card

Ê If applicable, remove the riser module 1, see section
module 1 (HL)" on page
Ê If applicable, remove the riser module 2, see section
module 2 (HL)" on page
Ê Remove the expansion card, see section
from a riser module" on page
RX2540 M4
"Onboard indicators and controls" on page
74.
78.
283.
Upgrade and Maintenance Manual
Expansion cards and backup units
"Removing the riser
"Removing the riser
"Removing an expansion card
551.
287