Reconfiguring The Backup Software Solution; Resetting The Boot Retry Counter; Viewing The Boot Retry Counter - Fujitsu PRIMERGY RX2540 M4 Upgrade And Maintenance Manual

Basic software procedures
Ê Modify the expansion card firmware options as desired.
Ê Save your changes and exit the firmware.
I
The option ROM of the expansion card can now be disabled in the BIOS.
Exception: If the expansion card controls a permanent boot device, the
Option ROM of the expansion card has to remain enabled.
5.2.5

Reconfiguring the backup software solution

I
This task only applies to Japan.
Disabling backup drives
Depending on the backup software solution, it may be necessary to disable or
delete the backup drive from the backup software drive list and reconfigure
backup jobs after completing the maintenance task.
I
More information on suitable backup software solutions and related
documentation is available from the Fujitsu web pages.
Re-enabling backup drives
If a backup drive has been disabled or deleted from the backup software drive
list as described in section
solution" on page
Ê Re-enable backup drives and revise backup software settings and cronjobs.
I
More information on suitable backup software solutions and related
documentation is available from the Fujitsu web pages.
5.2.6

Resetting the boot retry counter

The boot retry counter is decremented from its preset value every time the
POST watchdog initiates a system reboot. When the value has reached '0', the
system will shut down and power off.
5.2.6.1

Viewing the boot retry counter

The current boot retry counter status is available in the BIOS:
102
"Verifying and configuring the backup software
94, it has to be re-enabled to complete the maintenance task.
Upgrade and Maintenance Manual
RX2540 M4