Fujitsu PRIMERGY RX2540 M4 Upgrade And Maintenance Manual page 446

Front panel
Figure 327: Connecting the front panel cables
Ê Connect the following cables to the system board:
1 Front panel cable
2 If applicable, front VGA cable
3 Front USB3.0 cable
Ê If applicable, connect the ODD cable to the ODD.
Ê If applicable, install the riser module, see section
cards (FL)" on page
Ê Carefully pull the front panel module into its bay and regard that the locking
mechanism snaps in (see circle and figure
page 447).
V
CAUTION!
Ensure that none of the cables are strained or damaged.
I
The locking mechanism differs for the installations with LTO drives
because the drive need more place, so that an other locking recess point
is needed.
446
82.
Upgrade and Maintenance Manual
"Riser modules for GPGPU
328 on page 447 / 329 on
RX2540 M4