Front Panel Module (3.5-Inch Version) - Fujitsu PRIMERGY RX2540 M4 Upgrade And Maintenance Manual

Front panel
14.6

Front panel module (3.5-inch version)

14.6.1 Replacing the front panel module
Field Replaceable Unit
(FRU)
Tools: Phillips PZ2 / (+) No.2 screw driver (for the fan holder)
Note on system information backup/restore
The front panel (front panel module, front panel board or front panel on QRL)
contains the Chassis ID EPROM that contains system information like server
name and model, housing type, serial number and manufacturing data.
To avoid the loss of non-default settings when replacing the system board, a
backup copy of important system configuration data is automatically stored from
the system board NVRAM to the Chassis ID EPROM.
V
CAUTION!
For that reason the front panel and system board must not be replaced
simultaneously! In this case, restoring the system configuration data on
the system board would fail.
When replacing the front panel, the system information like server name and
model, housing type, serial number and manufacturing data are not restored
automatically. So never forget to restore it manually by Chassis ID Prom Tool.
14.6.1.1 Preliminary steps
"Locating the defective server" on page 53
Ê
"Suspending BitLocker functionality" on page 91
Ê
"Shutting down the server" on page 55
Ê
"Disconnecting the power cord" on page 56
Ê
"Getting access to the component" on page 58
Ê
"Removing the fan holder" on page 233
Ê
468 Upgrade and Maintenance Manual
Hardware: 10 minutes
Software: 5 minutes
RX2540 M4