Connecting Cables To The Expansion Card; Concluding Steps - Fujitsu PRIMERGY CX2560 M4 Upgrade And Maintenance Manual

Ê If applicable, install SFP+ transceiver modules on the new expansion card,
see section "Installing SFP+ transceiver modules" on page
6.2.1.3

Connecting cables to the expansion card

Ê If applicable, connect internal cables to the expansion card.
I
For a complete cabling overview, see section
6.2.1.4

Concluding steps

Perform the following procedures:
"Installing the riser module" on page 55
Ê
"Installing the server node in the server enclosure" on page 67
Ê
Ê Reconnect all external cables.
"Controls and indicators on the server node" on page 448
Ê
"Updating expansion card firmware" on page 83
Ê
"After replacing/upgrading LAN controllers" on page 100
Ê
CX2550/60/70 M4
Expansion cards and OCP mezzanine cards
Upgrade and Maintenance Manual
This is the good case.
This is the bad case.
"Cabling" on page
(if applicable)
172.
421.
(if applicable)
121