Remove The Rear Air Grid Riser Module 2; Concluding Steps; Removing An Expansion Card From Riser Module 2; Preliminary Steps - Fujitsu PRIMERGY RX2540 M4 Upgrade And Maintenance Manual

9.9.3.5

Remove the rear air grid riser module 2

Ê Remove the rear air grid riser module 2, see section
grid riser module 2" on page
9.9.3.6

Concluding steps

Ê Install the riser module 2, see section
page 79.
"Reassembling" on page 63
Ê
Ê Connect all external cables to the expansion card(s).
"Connecting the power cord" on page 67
Ê
"Switching on the server" on page 70
Ê
Ê If applicable, "Updating expansion card firmware" on page
Ê If applicable, "Enabling Option ROM scan" on page
"Resuming BitLocker functionality" on page 112
Ê
9.9.4

Removing an expansion card from riser module 2

Upgrade and Repair Unit
(URU)
Tools: Phillips PZ2 / (+) No. 2 screw driver / hexagon screw driver 5 mm
9.9.4.1

Preliminary steps

Ê If applicable, "Locating the defective server" on page 53
"Suspending BitLocker functionality" on page 91
Ê
"Shutting down the server" on page 55
Ê
Ê Remove all external cables from the expansion card to be removed.
I
If there is a cable installed to an expansion card in the upper slot, see
section
11" on page
RX2540 M4
279.
"Note for installation with expansion cards in slot 5 and slot
71.
Upgrade and Maintenance Manual
Expansion cards and backup units
"Removing the rear air
"Installing the riser module 2 (HL)" on
101.
Hardware: 5 minutes
Software: 5 minutes
100.
285