Concluding Steps - Fujitsu PRIMERGY RX2540 M4 Upgrade And Maintenance Manual

Ê Slide the holder in direction of the arrow (1).
The shoulder screw caps on the riser card holder will lock in the narrow ends
of the keyhole slots on the holder.
Ê Ensure that the locking handle on the holder properly snaps in place (2).
Ê If applicable, install the TFM, see section
page 311.
Ê Connect the FBU cable to the TFM, see section
page 311.
Ê Connect the cable end on the FBU to the FBU cable (see figure
page 318, 3).
Ê Install the RAID controller, see section
page 253.

9.11.3.4 Concluding steps

"Reassembling" on page 63
Ê
"Connecting the power cord" on page 67
Ê
"Switching on the server" on page 70
Ê
Ê If applicable, "Updating expansion card firmware" on page
9.11.4 Removing an FBU from the air duct
Upgrade and Repair Unit
(URU)
Tools: tool-less
V
CAUTION!
Dispose of used battery properly. Keep away from children.
●
Do not throw flash backup units into the trash can. Batteries must be
●
disposed of in accordance with local regulations concerning special
waste.
RX2540 M4
Upgrade and Maintenance Manual
Expansion cards and backup units
"Installing the new TFM" on
"Installing the new TFM" on
"Installing an expansion card" on
Hardware: 5 minutes
214 on
100.
319