Do not extend more than one server out of the rack simultaneously
●
even if the tilt protection is in place. If several servers are
simultaneously extended from the rack, there is a risk that the rack
could tip over. See the safety information of the rack and the warning
label.
If the server/rack is intended for permanent connection to the mains
●
only an authorized specialist (electrician) is allowed to work.
Please follow the regulation of each country.
If the server is integrated into an installation that draws power from an
●
industrial power supply network with an IEC309 type connector, the
power supply's fuse protection must comply with the requirements for
non-industrial power supply networks for the type A connector.
Other important information
During cleaning, observe the instructions in the corresponding Operating
●
Manual chapter "Starting up and operation" > "Cleaning the server".
Keep all manuals close to the server. All documentation must be included if
●
the equipment is passed on to a third party.
3.2
CE conformity
The system complies with the requirements of European
Regulations. Find the CE declaration on certificate portal:
https://sp.ts.fujitsu.com/sites/certificates/default.aspx
To open the CE declaration applicable for your system, proceed
as follows:
Ê Select Industry Standard Servers.
Ê Select your model, e.g. Rack server.
Ê Select your system, e.g. PRIMERGY RX2530 M1.
Ê Select CE Cert <your system>.
V
RX2540 M4
CAUTION!
This is a Class A product. In a domestic environment this
product may cause RF interference, in which case the
user may be required to take adequate measures.
Upgrade and Maintenance Manual
Important information
49