Replacing The Id Card Holder - Fujitsu PRIMERGY RX2540 M4 Upgrade And Maintenance Manual

"Connecting the power cord" on page 67
Ê
"Switching on the server" on page 70
Ê
"Verifying system information backup/restore" on page 99
Ê
Ê Store your server's system information on the Chassis ID EPROM
integrated into the front panel board. For more information on how to obtain
and use the ChassisId_Prom Tool, see section
Tool" on page
"Resuming BitLocker functionality" on page 112
Ê

14.5.2 Replacing the ID card holder

Field Replaceable Unit
(FRU)
Tools: tool-less
14.5.2.1 Preliminary steps
"Suspending BitLocker functionality" on page 91
Ê
"Locating the defective server" on page 53
Ê
"Shutting down the server" on page 55
Ê
"Disconnecting the power cord" on page 56
Ê
Ê If applicable, "Removing 2.5-inch HDD/SSD modules" on page
"Getting access to the component" on page 58
Ê
"Removing the fan holder" on page 233
Ê
Ê Remove the backplane 3 see section
page 191.
14.5.2.2 Removing the ID card holder
Ê Remove the ID card, see figure
RX2540 M4
118.
Upgrade and Maintenance Manual
"Using the Chassis ID Prom
Hardware: 10 minutes
"Removing the HDD backplane" on
409 on page 544.
Front panel
185.
465