Removing The Defective System Board - Fujitsu PRIMERGY RX2540 M4 Upgrade And Maintenance Manual

"Shutting down the server" on page 55
Ê
"Disconnecting the power cord" on page 56
Ê
Ê Disconnect all external cables.
Ê Remove the PSUs see,
"Getting access to the component" on page 58
Ê
"Removing the air duct" on page 88
Ê
"Removing the fan holder" on page 233
Ê
Ê Remove all memory modules, see section
page 341.
I
Before removing the memory modules, take a note on the installation
slot number for each memory module. Ensure that you install the
memory modules in the slot they were located before the
replacement.
Ê If applicable, remove the riser modules, see section
modules" on page
Ê Expansion cards, see section
I
Before removing the expansion cards, take a note on the installation
slot number for each card. Ensure that you install the card in the slot
it was located before the replacement.
Ê Remove the OCP module (if applicable), see section
module" on page
Ê Remove the iRMC microSD card (if applicable), see section
iRMC microSD card" on page
Ê If applicable, remove all M.2 SSDs, see section
page 521.
Ê If applicable, remove the Dual microSD 64GB Enterprise, see section
"Removing the Dual microSD 64GB Enterprise" on page

16.7.1.2 Removing the defective system board

Ê Disconnect all cables from the system board.
RX2540 M4
section"Removing a hot-plug PSU" on page
71.
"Removing an expansion card" on page
250.
515.
Upgrade and Maintenance Manual
System board and components
"Removing a memory module" on
"Handling riser
"Removing the OCP
"Removing the M.2 SSD" on
529.
132.
263.
"Removing the
537