Connecting The Cables To The Sas Expander Board; Concluding Steps - Fujitsu PRIMERGY RX2540 M4 Upgrade And Maintenance Manual

Hard disk drives (HDD) and solid state drives (SSD)
Figure 112: Connecting cables - with SAS expander board (backplane 3)
Ê Connect the two SAS/SATA cables to the backplane 3:
1 Cable C32 to backplane connector "X10"
2 Cable C31 to backplane connector "X9"
Ê Connect the power cables to the backplane 1:
3 Power cable
4 If applicable, ODD power cable
5 If applicable, OOB cable
7.4.9.9

Connecting the cables to the SAS expander board

Ê If applicable, install the SAS expander board holder, see section
the SAS expander board holder" on page
Ê If applicable, install the SAS expander board holder, see section
"Connecting the SAS expander board" on page

7.4.9.10 Concluding steps

"Installing the fan holder" on page 234
Ê
"Reassembling" on page 63
Ê
"Installing 2.5-inch HDD/SSD modules" on page 182
Ê
"Connecting the power cord" on page 67
Ê
"Switching on the server" on page 70
Ê
"Resuming BitLocker functionality" on page 112
Ê
198 Upgrade and Maintenance Manual
203.
204.
"Installing
RX2540 M4