Syntax
Attribute
Summary
Programming Commands
UNIT Subsystem
Non-sequential command
Always use an *OPC? query or a *WAI command to ensure that this command has the
time to complete before sending any more commands to the instrument.
"Always force the Agilent 86120B to wait for non-sequential commands" on page 4-12
for more information.
UNIT Subsystem
The only command provided in this subsystem is the POWer command as
shown in the following command hierarchy:
:UNIT
[:POWer]
[:POWer]
Sets the power units to watts (linear) or dBm (logarithmic).
:UNIT[:POWer]{?| {W | DBM}}
Preset State: dBm
*RST State: dBm
SCPI Compliance: standard
5-86
Refer to