AudioCodes Mediant 4000 SBC User Manual page 991

CHAPTER 60 Configuration Parameters Reference
'V.32 Modem Transport Type'
configure voip > media fax-modem >
V32-modem-transport-type
[V32ModemTransportType]
'V.34 Modem Transport Type'
configure voip > media fax-modem >
V34-modem-transport-type
[V34ModemTransportType]
bell-modem-transport-type
[BellModemTransportType]
'Fax CNG Mode'
configure voip > media fax-modem >
fax_cng_mode
[FaxCNGMode]
Parameter
- 958 -
Mediant 4000 SBC | User's Manual
Description
Note: You can also configure this feature
per specific calls, using IP Profiles
(IpProfile_VxxTransportType). For more
information, see Configuring IP
Determines the V.32 modem transport
type.
■ [0] Disable = Transparent.
■ [2] Enable Bypass (default)
■ [3] Events Only = Transparent with
Events.
Note:
■ The parameter applies only to V.32
and V.32bis modems.
■ You can also configure this feature
per specific calls, using IP Profiles
(IpProfile_VxxTransportType). For
more information, see
Profiles.
Determines the V.90/V.34 modem
transport type.
■ [0] Disable = Transparent.
■ [2] Enable Bypass (default)
■ [3] Events Only = Transparent with
Events.
Note: You can also configure this feature
per specific calls, using IP Profiles
(IpProfile_VxxTransportType). For more
information, see Configuring IP
Determines the Bell modem transport
method.
■ [0] Disable = Transparent.
■ [2] Enable Bypass (default)
■ [3] Events Only = Transparent with
Events.
Determines the device's handling of fax
relay upon detection of a fax CNG tone
from originating faxes.
■ [0] Doesn't send T.38 Re-INVITE =
(Default) SIP re-INVITE is not sent.
■ [1] Sends on CNG tone = Sends a
SIP re-INVITE with T.38 parameters
in SDP to the terminating fax upon
detection of a fax CNG tone, if the
CNGDetectorMode parameter is set
to 1.
Profiles.
Configuring IP
Profiles.