Timing Chain Cover - Suzuki Ignis Service Manual

TIMING CHAIN COVER

[A] : Sealant application
amount
"a" : 3 mm (0.12 in.)
"b" : 2 mm (0.08 in.)
1. Crankshaft pulley bolt
2. Crankshaft pulley
3. Oil seal
: Apply engine oil to oil seal lip.
4. Timing chain cover
: Apply sealant 99000-31140 to the mating surface
of cylinder and cylinder head.
: Apply sealant 99000-31150 to the mating surface
of timing chain cover referring to the figure of Step
1) in INSTALLATION.
5. Pin
6. Cylinder head gasket
7. Timing chain cover mounting bolts
REMOVAL
1) Disconnect negative cable at battery.
2) Disconnect the following electric lead wires, and remove
these connector bracket.
• CMP sensor
• Heated oxygen No.1 and No.2 sensors
• Engine oil pressure switch
ENGINE MECHANICAL (M13 ENGINE) 6A1-25
8. Oil pan mounting bolt
9. Oil pan mounting nut
10. Cylinder head cover
: Apply sealant 99000-31150 to the sealing
point for timing chain cover mating surface
and cylinder head gasket sealing point.
Refer to "CYLINDER HEAD COVER
INSTALLATION".
Tightening torque
Do not reuse.