Avaya Definity SI Maintenance Manual page 1646

Maintenance Object Repair Procedures
2. The example in
a successful test of the firmware download circuitry.
If the test does not pass, refer to the
Values''
Backing out of a firmware download
To revert back to the old firmware image file on TN799DP (C-LAN) or TN2501AP
(VAL) only:
1. At the SAT type get boot-image <UUCSS> and press
status of the firmware images on the target circuit pack.
The Display Firmware Image(s) report
get boot-image 1C07
Image 1
Board Type: TN2501
FW Vintage: 02
HW Signature: 02
Suffix: A
Date: 03/02/02
Timestamp: 10:30:50
CRC Checksum: Good
Active Image: Yes
Reboot Image: Yes
Screen 10-14. Display Firmware Image(s) screen
2. Check the date and time stamps to determine whether to revert back to
Image 1 or Image 2. In the example that follows, we are reverting back to
Image 2, because it has the older date and time stamp.
3. At the SAT type set boot-image board <UUCSS> image <1 | 2> and
press
Example: set boot-image board 1C07 image 2
The system responds with Command Successfully Completed.
10-860 Issue 4 May 2002
Screen 10-13
section.
DISPLAY FIRMWARE IMAGE(S)
Image 2
TN2501
01
02
A
03/02/01
12:42:18
Good
No
No
.
Enter
NOTE:
In most cases the image with the more recent date and time stamp is
the new firmware image file.
shows PASS in the Result field, indicating
''Error Log Entries and Test to Clear
(Screen 10-14) appears.
to check the
RETURN
555-233-123