Avaya Definity SI Maintenance Manual page 1647

FW-DWNLD (Firmware Download)
4. At the SAT type get boot-image <UUCSS> and press
status of the firmware images on the target circuit pack.
The Display Firmware Image(s) report
get boot-image 1C07
Image 1
Board Type: TN2501
FW Vintage: 02
HW Signature: 02
Suffix: A
Date: 03/02/02
Timestamp: 10:30:50
CRC Checksum: Good
Active Image: Yes
Reboot Image: No
Screen 10-15. Display Firmware Image(s) screen
Note that the values in both the Active Image and the Reset Image
fields have changed.
5. Reseat the circuit pack to activate the new firmware image:
!
!
a. Release the latch handle to free the circuit pack from the carrier.
b. Pull the circuit pack out approximately 1-2 inches (2.54 to 5.08 cm.).
c. Re-insert the circuit pack into the carrier.
d. Close the latch securely.
Wait until all 3 of the top LEDs (red, green, and amber) are out.
555-233-123
DISPLAY FIRMWARE IMAGE(S)
Image 2
TN2501
01
02
A
03/02/01
12:42:18
Good
No
Yes
WARNING:
To prevent electrostatic discharge (ESD), be sure to wear a
grounding strap while handling the circuit pack.
CAUTION:
For TN2501AP (VAL) ensure that both the top green and top amber
LEDs are out.
RETURN
(Screen 10-15) appears.
Issue 4 May 2002
to check the
10-861