Avaya Definity SI Maintenance Manual page 1536

Maintenance Object Repair Procedures
Table 10-283. TEST #1286 Session Status Test
Error
Code
1124 ABORT
1125 ABORT
2000 ABORT
2100 ABORT
2500 ABORT
10-750 Issue 4 May 2002
Test
Result
Ethernet link is not enabled.
1. Verify that the Ethernet link is enabled (status port
UUCSSpp, status link n, or display data-module).
2. If the link is not enabled, enable the link (change
data-module).
3. Repeat the test.
4. Escalate if the problem persists.
Ethernet link not in service.
1. Verify whether Ethernet link is in service (status port
UUCSSpp or status link n).
2. If the Ethernet link is not in service, release the link (release
link n or release port UUCSSpp).
3. Repeat the test.
4. Escalate if the problem persists.
Did not receive circuit pack test response within the allowable
time period.
1. If the problem persists, reset the circuit pack (busyout
board UUCSSpp, reset board UUCSS, and release board
UUCSS).
2. If the problem persists, replace the circuit pack.
Could not locate the necessary system resources to run this
test.
1. Retry the command at 1-minute intervals, up to 5 times.
2. Escalate if the problem persists.
Internal system error.
1. Retry the command at 1-minute intervals, up to 3 times.
2. Escalate if the problem persists.
Description/Recommendation
Continued on next page
555-233-123