Avaya Definity SI Maintenance Manual page 1531

ETH-PT (Control LAN Ethernet)
TCP/IP PING Test (#1281)
This non-destructive test fails if all the endpoints fail to respond. Use this test to
check the circuitry in the data path for a peer-to-peer IP layer connection.
Table 10-281. TEST #1281 TCP/IP PING Test
Error
Code
1, 2, ABORT
11
7 ABORT
1005 ABORT
1124 ABORT
555-233-123
Test
Result
Internal error
1. Retry the command at 1-minute intervals a maximum of 3
times.
2. If the problem persists, escalate the problem.
Destination unreachable.
1. Verify that there is a destination to ping in the routing table
(list ip-route and look for destinations reachable through this
ethernet port).
2. If there are no reachable destinations from this port (i.e., no
routes administered on ethernet), administer a route and
retry.
3. Escalate if the problem persists.
Incorrect test configuration.
1. Verify Ethernet link is in service (status port UUCSSpp or
status link n).
2. Verify that Ethernet link is enabled (status port UUCSSpp
or status link n or display data-module).
3. Verify routing table has reachable destinations.
4. Repeat the test.
5. If problem persists while the Ethernet link is in service and
enabled, escalate the problem.
Ethernet link is not enabled.
1. Verify that the Ethernet link is enabled (status port
UUCSSpp, status link n, or display data-module).
2. If the link is not enabled, enable the link (change
data-module).
3. Repeat the test.
4. Escalate if the problem persists.
Description/Recommendation
Continued on next page
Issue 4 May 2002 10-745