4.
Touch the four [x] positions displayed on the LCD.
u NOTE u
For the machines of #50001 and later, and #60001 and later, use an item with a
thin tip that will not scratch the screen, like a touch panel pen, to touch the center
points of [x].
If you touch the points with your finger, the position error between the touched
points and the points responded by the panel will become broader and the
response of the touch panel may get worse.
→The main screen of the Machine Maintenance comes back in several seconds.
5.
Touch the [Touch Point Check] button.
011-202-11E
06.29.2012 FM6046
6.
Touch any area on the LCD at several positions.
Make sure that the "x" mark appears at the position touched.
u NOTE u
If the "x" mark is misaligned from the touched position, repeat steps 3 through 6
all over again.
7.
Turn OFF the power of the RU.
8.
Turn ON the power of the RU.
CR-IR 363 Service Manual
MC-23
MC-23