FujiFilm PROFECT CS Service Manual page 446

7.
Make sure that the IP address of the RU selected at step 6 is displayed,
and click on [OK].
u NOTE u
If the CL screen does not change and the initialization of the application does not
proceed after clicking on "OK", turn ON the DIP SW-No.6 on the CPU91A board,
and the application need be initialized. Refer to "Appendix 1. Procedures for
Restoring the Application by means of DIP SW-No.6 of the CPU91A Board".
{MT: Appendix 1._Procedures for Restoring the Application by means of DIP
SW-No.6 of the CPU91A Board}
8.
Once the initialization of the application is completed, press the [Enter]
key.
REFERENCE
The initialization of the application takes about 2 minutes.
011-202-07
09.30.2008 FM5340
9.
Turn OFF the power of the RU.
10.
Restore the DipSW1 No. 4 switch to its original setting.
11.
Reinstall the cover.
- Upper right-hand side cover
{MC:3.1_Covers}
12.
Turn ON the power of the RU.
REFERENCES
- It takes about three minutes until the screen appears on the touch panel after
the RU is powered ON.
- When the RU is powered ON, the following screen appears on the touch panel,
and it boots up to the Maintenance Mode.
- When RU software version 1.2 or later is used, the [Return] button in the lower
right corner of the touch panel is hidden.
CR-IR 363 Service Manual
MT-289
MT-289