FujiFilm PROFECT CS Service Manual page 231

4.16 Error Code Analysis Flow: Mechanism 16
10420, 10422, 10425, 10426
n Analysis Flow
Q1
RU software is of version 1.5 or later?
N
Update the RU software to the version 1.5 or later.
Y
{MC:15._Updating Software Versions}
m Check the error log in the ERROR DB.
Q2
The indicated error is at the beginning of the error log?
{MT:1.4_Troubleshooting from Error Log}
N
Check the error code table again for the error at the beginning, and troubleshoot.
Y
{MT:2._Error Code Table}
Q3
Power supply error (12810-12875) occurs?
Y
Check the error code table again and troubleshoot.
N
{MT:2._Error Code Table}
Perform preparation procedures in the order named.
m
1. Secure space for servicing the machine.
2. Remove the covers.
3. Turn OFF the high-voltage switch of the SCN17A/SCT17B board.
A
m Check the voltage on the CPU91A and DRV17A boards.
{MT:8._Procedures for Checking the Voltage}
Q4
CPU91A, DRV17A/B, and SNS17A/B boards tested in MUTL normal?
{MT:18._Board Test in MUTL}
N
Q14
Y
Q5
Check the sensors (SB1, SB2, SB3, and SB4).
{MT:10._Procedures for Checking the Sensors}
Q6
011-202-04
11.15.2004 FM4425
Q6
Check the sensor (SB6).
{MT:10._Procedures for Checking the Sensors}
Q7
Check the sensors (SB7, SB8, and SB9).
{MT:10._Procedures for Checking the Sensors}
Q8
Check the sensor (SB11).
{MT:10._Procedures for Checking the Sensors}
Q9
Check the sensor (SG1).
{MT:10._Procedures for Checking the Sensors}
Q10
Check the sensor (SE1).
{MT:10._Procedures for Checking the Sensors}
Q11
Check the sensor (SE2).
{MT:10._Procedures for Checking the Sensors}
Q12 Check the solenoids (SOLA1, SOLA2, SOLA3, and SOLA4).
{MT:12._Procedures for Checking the Actuators}
Q13
CR-IR 363 Service Manual
MT-74
MT-74