Checking Laser On In Mutl - FujiFilm PROFECT CS Service Manual

13.2

Checking Laser ON in MUTL

n Procedures
1.
Remove the cover.
- Upper right-hand side cover
{MC:3.1_Covers}
2.
Start the MUTL.
{MU:5.2.1_Starting the MUTL}
3.
Turn ON the laser.
Check the display on the MUTL.
TURNNING ON THE LASER IS IN PROGRESS..
LDIFINT : 300
LDIFNOW : 132
LDIFNOW/LDIFINT : 44
RESULT-OK
If an error code is displayed on the MUTL, instead of "RESULT-OK", then refer to the
error code table and troubleshoot as appropriate.
{MT:2._Error Code Table}
011-202-04
11.15.2004 FM4425
4.
Check to see whether the LEDs on the SCN17A/SCT17B board are
normal.
l GOOD indication
No abnormality exists if the indication is other than the NO GOOD indication.
u NOTE u
The "HVON" LED display varies depending on the state of the high-voltage
switch. Thus, check the state of the high-voltage switch.
- High-voltage switch ON → LED illuminated
- High-voltage switch OFF → LED not illuminated
l NO GOOD indication
CR-IR 363 Service Manual
MT-232
MT-232