FujiFilm PROFECT CS Service Manual page 177

Error
Error Name
Code
Driving-shaft grip correction error
10416
(4)
Driving-shaft grip correction error
10417
(1)
Driving-shaft grip correction error
10418
(2)
Driving-shaft grip correction error
10419
(3)
10420 IP-initialization IP search error (1)
10421 IP-initialization IP search error (2)
011-202-04
11.15.2004 FM4425
For the correction processing during bootup/at the end of reading, the grip drive motor (MZ2) is driven to correct
the grip speed of the driving shaft for the GR type; however, the driving-side grip release HP sensor (SZ2) does not
transition to OPEN within the specified period of time.
After three times or more grip speed correction are executed, SZ2 does not transition to OPEN within the specified
period of time, so that the system goes down.
For the correction processing during bootup/at the end of reading, the grip drive motor (MZ2) is driven to correct
the grip speed of the driving shaft for the ST type; however, the driving-side grip release HP sensor (SZ2) does not
transition to OPEN within the specified period of time.
Alternatively, the MZ2 does not transition to the interlocked state, then three times or more grip speed correction are
executed, however, SZ2 does not transition to OPEN within the specified period of time, so that the system goes
down.
For the correction processing during bootup/at the end of reading, the grip drive motor (MZ2) is driven to correct the
grip speed of the driving shaft for the HR single-side type; however, the driving-side grip release HP sensor (SZ2)
does not transition to OPEN within the specified period of time.
Alternatively, the MZ2 does not transition to the interlocked state, then three times or more grip speed correction
are executed, however, SZ2 does not transition to OPEN within the specified period of time, so that the system
goes down.
For the correction processing during bootup/at the end of reading, the grip drive motor (MZ2) is driven to correct
the grip speed of the driving shaft for the HR both-side type; however, the driving-side grip release HP sensor (SZ2)
does not transition to OPEN within the specified period of time.
Alternatively, the MZ2 does not transition to the interlocked state, then three times or more grip speed correction are
executed, however, SZ2 does not transition to OPEN within the specified period of time, so that the system goes
down.
During bootup, two or more sensors of the IP feed/load sensors (SB1/2/3/4) are CLOSE for the remaining IP search
processing, so that the system goes down.
Several IPs are detected at the cassette set unit.
During bootup, two or more sensors of the path changeover HP sensor (SB11) and path changeover shelf sensor
(SB7/8/9) are CLOSE for the remaining IP search processing.
Occurrence Condition
CR-IR 363 Service Manual
MT-20
Analysis
Flow
{MT:4.15}
{MT:4.15}
{MT:4.15}
{MT:4.15}
{MT:4.16}
{MT:4.7}
MT-20