FujiFilm PROFECT CS Service Manual page 408

9.
Drive the subscanning motor (MZ1).
Repeat steps 7 through 9 to check the following points.
If anything abnormal is found, replace the FFM motor.
l RESULT-OK is displayed
If an error code is displayed in the "OK" portion of RESULT-OK, then refer to the
error code table and troubleshoot as appropriate.
l The wow/flutter is held below the reference
The wow/flutter is held below 0.6%.
l There is no offensive noise
There is no offensive noise during rotation of the FFM motor.
If any offensive noise is found, remedy it.
10.
Stop the subscanning motor (MZ1)
11.
Exit the MUTL.
{MU:5.2.2_Exiting the MUTL}
12.
Turn OFF the power of the machine.
13.
Reinstall the lower right-hand side cover and lower left-hand side
cover.
{MC:3.1_Covers}
14.
Turn ON the high-voltage switch (S1) located on the SCN17A/SCT17B
board.
011-202-04
11.15.2004 FM4425
CR-IR 363 Service Manual
MT-251
MT-251