FujiFilm PROFECT CS Service Manual page 176

Error
Error Name
Code
10403 IP stopper HP detection error
10406 IP stopper protrusion error
10410 Driving-shaft grip release error
10411 Driving-shaft grip error
10412 Driving-shaft fast grip error
10413 Driven-shaft grip release error
10414 Driven-shaft grip error
10415 Driven-shaft fast grip release error
011-202-01
08.25.2003 FM4098
During bootup/M-Utility, the IP stopper drive motor (MZ4) is driven to perform home-positioning of the IP stopper;
however, the OPEN or CLOSE of the IP stopper HP sensor (SZ5) is not detected. After two retries are executed,
this is not detected, so that the system goes down.
During bootup/routine processing/M-Utility, the IP stopper drive motor (MZ4) is stopped to protrude the IP stopper;
however, the OPEN or CLOSE of the IP stopper HP sensor (SZ5) is not detected. After two retries are executed,
this is not detected, so that the system goes down.
During routine processing/M-Utility, the grip drive motor (MZ2) is driven to perform grip release operation for the
driving shaft; however, the driving-side grip release HP sensor (SZ2) does not transition to CLOSE within the
specified period of time.
During routine processing/M-Utility except for secondary erasure, the grip drive motor (MZ2) is driven to perform
grip operation for the driving shaft; however, the driving-side grip release HP sensor (SZ2) does not transition to
OPEN within the specified period of time.
During routine processing/M-Utility, the grip drive motor (MZ2) is driven at high speed to perform grip operation for
the driving shaft; however, the driving-side grip release HP sensor (SZ2) does not transition to OPEN within the
specified period of time.
During routine processing/M-Utility except for secondary erasure, the grip drive motor (MZ2) is driven at high speed
to perform grip release operation for the driven shaft; however, the driven-side grip release HP sensor (SZ3) does
not transition to OPEN within the specified period of time.
During routine processing/M-Utility, the grip drive motor (MZ2) is driven to perform grip release operation for
the driven shaft; however, the driven-side grip release HP sensor (SZ3) does not transition to CLOSE within the
specified period of time.
During secondary erasure/M-Utility, the grip drive motor (MZ2) is driven at high speed to perform grip release operation
for the driven shaft; however, the driven-side grip release HP sensor (SZ3) does not transition to OPEN within the
specified period of time.
Occurrence Condition
CR-IR 363 Service Manual
MT-19
Analysis
Flow
{MT:4.14}
{MT:4.14}
{MT:4.15}
{MT:4.15}
{MT:4.15}
{MT:4.15}
{MT:4.15}
{MT:4.15}
MT-19