FujiFilm PROFECT CS Service Manual page 317

10.6.2 Check Procedures via LEDs on the SNS Board (3)
1.
Perform the procedures for starting the LED check.
{MT:10.3.1_Procedures for Starting the LED Check}
2.
Check the display of the LEDs located on the SNS17B board.
3.
Select IP Removal Unit.
4.
Execute Suction Cup Arm HP corresponding to the sensor to be
checked.
l To check SA4: Click on the [Shelf 1] button.
l To check SA10: Click on the [Shelf 2] button.
l To check SA16: Click on the [Shelf 3] button.
l To check SA22: Click on the [Shelf 4] button.
011-202-04
11.15.2004 FM4425
5.
Check the display of the LEDs located on the SNS17B board.
Make sure that the LEDs change (from ON to OFF, or from OFF to ON) during
operation.
l GOOD indication
The LEDs change.
l NO GOOD indication
The LEDs do not change.
6.
Perform the procedures for exiting the LED check.
{MT:10.3.2_Procedures for Exiting the LED Check}
CR-IR 363 Service Manual
MT-160
MT-160