FujiFilm PROFECT CS Service Manual page 178

Error
Error Name
Code
10422 IP-initialization IP search error (3)
10425 IP-initialization IP search error (1)
Initialization remaining IP ejection
10426
error
Dust removal HP detection error
10430
(1) (CCW)
Dust removal HP detection error
10431
(2) (CCW)
Dust removal HP detection error
10432
(3) (CW)
Dust removal HP detection error
10433
(4) (CW)
Dust removal HP detection error
10434
(5) (CW)
011-202-01
08.25.2003 FM4098
During bootup, the pre-convergence IP sensor (SB6) and side-positioning entrance IP sensor (SG1) are CLOSE,
and the post-reading conveyance standby IP sensor (SE1) or switchback standby IP sensor (SE2) is CLOSE for the
remaining IP search processing. There are three or more IPs in the machine.
During bootup, when the presence of the cassette is checked, the IP is detected at the cassette set unit, but no
cassette is present at the cassette set unit.
Additionally, the hold pin (SOLA1/2/3/4: ON) is not lowered.
During bootup, the IP is detected, one by one, at the feed/load conveyor unit, erasure conveyor unit, and side-
positioning conveyor unit for the remaining IP search.
During bootup, the dust removal motor (MZ3) is driven (counterclockwise) to perform home-positioning of the dust
removal mechanism; however, the dust removal HP sensor (SZ4) does not transition from CLOSE to OPEN to
CLOSE. After the retries (four times) are executed, the transition of SZ4 is not detected, so that the system goes
down.
During bootup, the dust removal motor (MZ3) is driven (counterclockwise) to perform home-positioning of the dust
removal mechanism; however, the dust removal HP sensor (SZ4) does not transition to OPEN within the specified
period of time.
During bootup, the dust removal motor (MZ3) is driven (clockwise) to perform home-positioning of the dust removal
mechanism; however, the dust removal HP sensor (SZ4) does not transition to CLOSE within the specified period of
time.
During bootup, the dust removal motor (MZ3) is driven (clockwise) to perform home-positioning of the dust removal
mechanism; however, the dust removal HP sensor (SZ4) does not transition to OPEN within the specified period of
time.
During bootup, the dust removal motor (MZ3) is driven (clockwise) to perform home-positioning of the dust removal
mechanism; however, the dust removal HP sensor (SZ4) does not transition to CLOSE within the specified period of
time.
Occurrence Condition
CR-IR 363 Service Manual
MT-21
Analysis
Flow
{MT:4.16}
{MT:4.16}
{MT:4.16}
{MT:4.17}
{MT:4.17}
{MT:4.17}
{MT:4.17}
{MT:4.17}
MT-21