FujiFilm PROFECT CS Service Manual page 201

Error
Error Name
Code
Driving-shaft grip speed correction
12418
failure
Dust removal HP detection
12430
warning
Dust removal HP detection retry
12433
(1)
Dust removal HP detection retry
12434
(2)
Initialization convergence path IP
12440
conveyance warning (1)
Initialization convergence path IP
12441
conveyance warning (2)
12510 Image format error
12520 Message transmission failure
12521 RES message receiving time-out
12522 ACK receiving time-out
12523 SET command CL receiving error
Forbidden Response to Start-
12524
Process command
011-202-11E
06.29.2012 FM6046
For the correction processing during bootup/at the end of reading, the grip drive motor (MZ2) is driven to perform
operation for correcting the grip speed of the driving shaft; however, the driving-side grip release HP sensor (SZ2)
does not transition to OPEN within the specified period of time.
During bootup and during routine processing, the home position of the dust removal mechanism is checked. As
the dust removal HP detection sensor (SZ4) is in CLOSE, the dust removal motor (MZ3) is activated for home-
positioning control.
During bootup, the dust removal motor (MZ3) is driven (counterclockwise) to perform home-positioning of the dust
removal mechanism; however, the dust removal HP sensor (SZ4) does not transition to OPEN within the specified
period of time, resulting in a retry.
During bootup, the dust removal motor (MZ3) is driven (counterclockwise) to perform home-positioning of the dust
removal mechanism; however, the dust removal HP sensor (SZ4) does not transition to CLOSE within the specified
period of time, resulting in a retry.
During bootup, the IP transport motor (MB1, MB2, MC3) is driven to perform the remaining IP search processing,
and before the side-positioning entrance IP sensor (SG1) and pre-convergence IP sensor (SB6) transition to OPEN,
the OPEN state of the pre-BCR IP sensor (SB5) is detected.
Because the IP may have been scratched, the IP should be checked for any scratch.
During bootup, the IP transport motor (MB1, MB2, MC3) is driven to perform the remaining IP search processing,
and the MB1, MB2, ME1 is stopped after the pre-convergence IP sensor (SB6) transitions to CLOSE; however, the
pre-BCR IP sensor (SB5) does not transition to OPEN.
Because the IP may have been scratched, the IP should be checked for any scratch.
During bootup or during routine processing, an illegal command is received from the CL.
During bootup or routine processing, a message transmission from RU to CL is failed.
During bootup or routine processing, a REQUEST message is transmitted from RU to CL, however, RU cannot
receive a RESPONSE message, thus resulting in a time-out.
During bootup or routine processing, a message is transmitted from RU to CL, however, RU cannot receive ACK,
thus resulting in a time-out.
Although the SET command was transmitted from the RU during routine processing, a signal other than OK was
received as a response from the CL. After the processed IP returns to a cassette, the cassette is ejected so that the
associated message appears on the RU panel.
Although the Start-Process command was transmitted from the RU to the CL immediately after cassette insertion
during routine processing, a rejection command was received from the CL. After the processed IP returns to a
cassette, the cassette is ejected so that the associated message appears on the RU panel.
Occurrence Condition
CR-IR 363 Service Manual
MT-44
Analysis
Flow
{MT:4.15}
{MT:4.17}
{MT:4.17}
{MT:4.17}
{MT:4.18}
{MT:4.18}
-
{MT:14.}
{MT:14.}
{MT:14.}
-
{MT:14.}
MT-44