FujiFilm PROFECT CS Service Manual page 860

10.
Remove the CPU91A board.
{MC:13.2_CPU91A Board}
11.
Remove the IMG17A/B board, and install a new IMG17A/B board.
12.
Reinstall the CPU91A board.
{MC:13.2_CPU91A Board}
011-202-11E
06.29.2012 FM6046
13.
Turn ON the power of the RU.
14.
Place the RU in the Maintenance Mode.
After the main screen appears, sequentially touch the upper left and upper right
corners of the touch panel.
u NOTE u
Because the IP address of the FTP server has not been set yet, it takes about
three minutes until the main screen appears.
p
REFERENCE
If your touch is accepted by the panel, a "beep" alarm sound is generated.
u INSTRUCTION u
If you cannot put the RU into the Maintenance Mode, turn OFF the power of the
RU and then reboot the RU all over again.
CR-IR 363 Service Manual
MC-371
MC-371