FujiFilm PROFECT CS Service Manual page 216

4.2 Error Code Analysis Flow: Mechanism 2
10347, 10348
n Analysis Flow
m Check the error log in the ERROR DB.
Q1
The indicated error is at the beginning of the error log?
{MT:1.4_Troubleshooting from Error Log}
N
Check the error code table again for the error at the beginning, and troubleshoot.
Y
{MT:2._Error Code Table}
Q2
Power supply error (12810-12875) occurs?
Y
Check the error code table again and troubleshoot.
N
{MT:2._Error Code Table}
m Perform preparation procedures in the order named.
1. Secure space for servicing the machine.
2. Remove the covers.
3. Turn OFF the high-voltage switch of the SCN17A/SCT17B board.
A
Q3
Error occurs only when a new IP is of large width size (35x35 (cm)/14x14 (inch)) or harf
width (14x17(inch))?
Y
Check the details of the error.
N
{MT:21._Troubleshooting Failures of New IP}
m Check the voltage on the CPU91A and DRV17A boards.
{MT:8._Procedures for Checking the Voltage}
Q4
CPU91A, DRV17A/B, and SNS17A/B boards tested in MUTL normal?
{MT:18._Board Test in MUTL}
N
Q11
Y
B
Q5
011-202-11E
06.29.2012 FM6046
Q5
MUTL indicates that the light-collecting mirror operation is normal?
{MU:5.3 [6-6-1]_Dust Removal HP}
N
Q12
Y
Q6
Check the sensor (SD2).
{MT:10._Procedures for Checking the Sensors}
Q7
Check the sensor (SZ1).
{MT:10._Procedures for Checking the Sensors}
Q8
Check the motor (MZ1).
{MT:11._Procedures for Checking the Motors}
Q9
Error recurs?
N
A
Y
m Replace the boards in the order named.
1. SNS17A/B board
{MC:13.7_SNS17B/SNS17C/SNS17E Board}
{MC:13.8_SNS17A/SNS17D Board}
2. DRV17A/B board
{MC:13.5_DRV17A Board}
{MC:13.6_DRV17B Board}
3. CPU91A board
{MC:13.2_CPU91A Board}
CR-IR 363 Service Manual
MT-59
MT-59