FujiFilm PROFECT CS Service Manual page 212

Error
Error Name
Code
13714 SNS17A/B board interrupt error
13715 INV17A/B register error
13716 Erasure lamp test error
Image processing CPU SDRAM
13717
test error
13718 Image processing FIFO test error
13719 Barcode communication error
13820 Barcode data read test error
Power supply monitoring register
13821
error
Insufficient resource for timer
19066
device
Insufficient resource for sync
19067
processing device
REFERENCE
The error code table is stored as an access file (.mdb) in the installation CD-ROM of the RU software. The following example shows a path on which the CR-IR 363 error code table is
stored when the installation CD-ROM of the RU software V2.4 is inserted into the D drive: D:\FujiFilm\FCR\CR-IR363\2.4\common\TOOL\EcodeMan.mdb.
Refer to the file in the installation CD-ROM when your information in the service manual is of an old version.
011-202-11E
06.29.2012 FM6046
An error is detected for the SNS17A/B interrupt in MUTL: Board Check.
An error is detected for the register of the INV17A/B board in MUTL: Board Check.
An error is detected for the erasure lamp test in MUTL: Board Check.
An error is detected for the SDRAM test of the image processing CPU in MUTL: Board Check.
An error is detected for the FIFO test of the image processing CPU in MUTL: Board Check.
An error is detected for the barcode communication test in MUTL: Board Check.
An error is detected for the barcode reading test in MUTL: Board Check.
An error is detected for the power supply monitoring register check in MUTL: Board Check.
During bootup or during routine processing, the resource for the timer device becomes insufficient.
During bootup or during routine processing, the resource for the sync processing device becomes insufficient.
Occurrence Condition
CR-IR 363 Service Manual
MT-55
Analysis
Flow
{MT:18.}
{MT:18.}
{MT:18.}
{MT:18.}
{MT:18.}
{MT:18.}
{MT:18.}
{MT:18.}
{MT:8.}
{MT:8.}
MT-55