Procedures For Restoring The Ru Application - FujiFilm PROFECT CS Service Manual

20.4 Procedures for Restoring the RU
Application
u NOTES u
- Once the procedures for restoring the RU application are performed, the machine
shipment control data of the RU is initialized. Check the IP addresses of the RU and
CL beforehand, and writhe them down on your notepad.
- After the procedures for restoring the RU application are performed, be sure to
perform the touch panel calibration procedures. Since the touch panel calibration
data does not exist, error code "13032" is logged whenever the machine is booted.
20.4.1

Procedures for Restoring the RU Application

1.
Turn OFF the power of the RU.
2.
Remove the cover.
- Upper right-hand side cover
{MC:3.1_Covers}
3.
Set No. 4 of the DIP SW of the CPU91A board to ON.
011-202-07
09.30.2008 FM5340
4.
Turn ON the power of the RU.
The RU boots up to the following state.
- The touch panel does not display anything and remains blank.
- Only the cassette IN and OUT lamps are illuminated.
5.
Put the RU-Appl CD-ROM into the CD-ROM drive of the CL.
6.
Perform the following procedures.
CR-IR 363 Service Manual
MT-288
MT-288