FujiFilm PROFECT CS Service Manual page 181

Error
Error Name
Code
Initialization side-positioning unit
10450
IP conveyance error (4) (UP)
Initialization erasure unit IP
10451
ejection error (1)
Initialization erasure unit IP
10452
ejection error (2)
Initialization erasure unit IP
10453
conveyance error
Initialization post-reading
10454 conveyor unit IP ejection error (1)
(UP)
Initialization post-reading
10455 conveyor unit IP ejection error (2)
(UP)
Initialization post-reading
10456 conveyor unit IP ejection error (3)
(DOWN)
Initialization subscanning unit IP
10457
ejection error (1)
011-202-04
11.15.2004 FM4425
During bootup, the IP transport motor (MC3) and subscanning motor (MZ1) are driven to perform the remaining IP
search processing; however, the side-positioning entrance IP sensor (SG1) does not transition to CLOSE within the
specified period of time. (In the case that the IP is detected in the side-positioning unit for the subscanning conveyor
unit processing.)
During bootup, the IP transport motor (MB1, MB2, ME1) is driven to perform the remaining IP search processing;
however, the pre-convergence IP sensor (SB6) does not transition to OPEN within the specified period of time.
During bootup, the IP transport motor (ME1) is driven to perform the remaining IP search processing; however, the
pre-convergence IP sensor (SB6) does not transition to CLOSE within the specified period of time.
During bootup, the IP transport motor (MD2, ME1) is driven at low speed to perform the remaining IP search
processing; however, the post-reading conveyance standby IP sensor (SE1) does not transition to OPEN within the
specified period of time.
During bootup, the IP transport motor (MD2) is driven to perform the remaining IP search processing; however,
the post-reading conveyance IP sensor (SD2) does not transition to OPEN within the specified period of time.
(In the case that the IP is detected in the post-reading conveyor unit also, during the IP search processing in the
subscanning unit.)
During bootup, the IP transport motor (MD2) and subscanning motor (MZ1) are driven to perform the remaining IP
search processing; however, the post-reading conveyance IP sensor (SD2) does not transition to OPEN within the
specified period of time.
During bootup, the IP transport motor (MD2) is driven to perform the remaining IP search processing; however, the
post-reading conveyance IP sensor (SD2) does not transition to CLOSE within the specified period of time.
During bootup, the IP transport motor (MD2) and subscanning motor (MZ1) are driven to perform the remaining IP
search processing; however, the post-reading conveyance IP sensor (SD2) does not transition to OPEN within the
specified period of time.
Occurrence Condition
CR-IR 363 Service Manual
MT-24
Analysis
Flow
{MT:4.19}
{MT:4.20}
{MT:4.20}
{MT:4.34}
{MT:4.35}
{MT:4.35}
{MT:4.35}
{MT:4.35}
MT-24