FujiFilm PROFECT CS Service Manual page 200

Error
Error Name
Code
Cleaning guide HP detection
12402
warning
12403 IP stopper HP detection retry (1)
12404 IP stopper HP detection retry (2)
12405 IP stopper HP detection retry (3)
IP stopper protrusion detection
12406
warning
12407 IP stopper HP detection warning
Suction cup HP detection warning
12408
(1)
Suction cup HP detection warning
12409
(2)
Driving-shaft grip velocity
12411
correction process operation
Driven-shaft grip release velocity
12413
correction process operation
Driving-shaft grip speed correction
12417
value warning
011-202-11E
06.29.2012 FM6046
During bootup/routine processing/M-Utility, the cleaning guide drive motor (MC4) is driven to release the grip of
the cleaning guide (guide-up); however, the cleaning guide HP sensor (SC4) does not transition to CLOSE, so that
home-positioning is performed.
During bootup/M-Utility, the IP stopper drive motor (MZ4) is driven for one pulse to perform IP stopper home-
positioning; however, the IP stopper HP sensor (SZ5) does not transition to CLOSE within the specified period of
time, thus resulting in a retry.
During bootup/M-Utility, the IP stopper drive motor (MZ4) is driven to perform IP stopper home-positioning; however,
the IP stopper HP sensor (SZ5) does not transition to CLOSE within the specified period of time, thus resulting in a
retry.
During bootup/M-Utility, the IP stopper drive motor (MZ4) is driven to perform IP stopper home-positioning; however,
the IP stopper HP sensor (SZ5) does not transition to OPEN within the specified period of time, thus resulting in a
retry.
During bootup/routine processing/M-Utility, the IP stopper drive motor (MZ4) is driven for IP stopper protruding
operation; however, the IP stopper HP sensor (SZ5) does not transition to OPEN, thus resulting in HP positioning.
During bootup/routine processing/M-Utility, the IP stopper drive motor (MZ4) is driven for IP stopper retreating
operation; however, the IP stopper HP sensor (SZ5) does not transition to CLOSE, so that home-positioning is
performed.
During bootup/routine processing/M-Utility, when the suction cup home position is checked, the suction cup HP
sensor (SA4/10/16/22) does not transition to CLOSE, so that home-positioning is performed.
During bootup/routine processing/M-Utility, when the suction cup home position is checked, the suction cup HP
sensor (SA4/10/16/22) does not transition to CLOSE, so that home-positioning is performed.
During routine processing/M-Utility except for secondary erasure, the grip drive motor (MZ2) is driven to perform
driving shaft grip operation; however, the variation of the grip speed within the allowable range is detected, so that
the speed is corrected.
During routine processing/M-Utility except for secondary erasure, the grip drive motor (MZ2) is driven to perform
driven shaft grip release operation; however, the variation of the grip release speed within the allowable range is
detected, so that the speed is corrected.
For the correction processing during bootup/at the end of reading, the grip speed of the driving shaft is corrected;
however, the driving-side grip release HP sensor (SZ2) does not transition to OPEN within the specified period of
time, thus resulting in a retry for grip speed correction.
Occurrence Condition
CR-IR 363 Service Manual
MT-43
Analysis
Flow
{MT:4.13}
{MT:4.14}
{MT:4.14}
{MT:4.14}
{MT:4.14}
{MT:4.14}
{MT:4.32}
{MT:4.32}
-
-
{MT:4.15}
MT-43