FujiFilm PROFECT CS Service Manual page 203

Error
Error Name
Code
Back-side communication receive
12697
size error
CPU board initial diagnostic test
12700
error
12701 Bus error detection function error
12702 H8 CPU interrupt error
12703 Sensor board interrupt error
12705 LCD bus error
High-temperature error detection
12733
(during erasure initialization)
Single lamp unlit detection (during
12736
erasure initialization)
Erasure unit high-temperature
12743
error cancel
Erasure unit high-temperature
12753
error
Single lamp unlit detection (during
12756
erasure idle temperature control)
Single lamp unlit detection (during
12766
IP erasure lighting)
011-202-11E
06.29.2012 FM6046
During bootup, or during routine processing, or in the Maintenance Utility, communication between the CPU91A
board and SCT17B board can be done; however, data size error is detected from the SCT17B board.
<Servicing>
It occurs when setup is made through DIP SW setting on the CPU91A board to perform total memory test during
bootup. During bootup, error is detected for the total memory test.
An error is detected for the bus error detection function on the CPU91A board performed during bootup or routine
processing.
During bootup or during routine processing, an interrupt test is conducted for "H8 CPU" of the scanner board
(SCN17A/SCT17B) from the CPU91A board, but it does not end normally.
During bootup or during routine processing, an interrupt test is conducted for the sensor board (SNS17A/SNS17B)
from the CPU91A board, but it does not end normally.
During bootup, the CPU91A board detects a bus error for the LCD panel.
During bootup, the temperature thermistor (THE1) detects high-temperature error.
During bootup, because one of the five lamps is unlit, the machine is booted up in the mode where the erasure time
is extended.
During bootup and routine processing, 12733 or 12753 occurs and the temperature of the erasure unit lamp reaches
an abnormal level, so that the no-erasure mode is temporarily entered.
Subsequently, because the erasure lamp temperature drops below the specified temperature (erasable
temperature), the normal mode is returned.
During routine processing and idling, the temperature thermistor (THE1) detects high-temperature error.
During idling, when the erasure lamps are turned on for erasure temperature control, a single lamp that is normally
lit does not turn on, so that it enters the erasure time extension mode.
During bootup and routine processing, when the erasure lamps are turned on during IP erasure, a single lamp is
unlit, so that it enters the erasure time extension mode.
Occurrence Condition
CR-IR 363 Service Manual
MT-46
Analysis
Flow
{MT:5.19}
-
{MT:18.}
{MT:6.1}
{MT:6.3}
{MT:18.}
{MT:6.4}
{MT:6.2}
{MT:6.4}
{MT:6.4}
{MT:6.2}
{MT:6.2}
MT-46