FujiFilm PROFECT CS Service Manual page 116

I/O No. Load name
MB1 IP transport motor
MB2 IP transport motor
MB3 Convergence path changeover guide
driving motor
MC 1 Side-positioning motor
MC 2 Grip release motor
MC 3 IP transport motor
MC 4 Cleaning guide driving motor
MZ4 IP stopper driving motor
ME 2 Side-positioning motor
SOLE1 Branch path changeover guide driving
solenoid
SOLB1 Not used
011-202-11E
06.29.2012 FM6046
Significance when LED is illuminated
The motor is driven: The IP in the feed/load conveyor unit is
conveyed.
The motor is driven: The IP in the feed/load conveyor unit is
conveyed.
The motor is driven: The convergence conveyance
changeover guide of the feed/load conveyor unit is
actuated.
The motor is driven: The side-positioning mechanism of the
side-positioning conveyor unit is actuated.
The motor is driven: The grip mechanism of the side-
positioning conveyor unit is actuated.
The motor is driven: The IP in the side-positioning conveyor
unit is conveyed.
The motor is driven: The cleaning guide of the side-
positioning conveyor unit is actuated.
The motor is driven: The IP stopper of the subscanning unit
is actuated.
The motor is driven: The side-positioning mechanism of the
erasure conveyor unit is actuated.
Solenoid ON: The branch path changeover guide of the
feed/load conveyor unit is actuated.
Not used
3.4.2 Meaning of LED ON (Illuminated)
An LED segment ON (illuminated) means that its corresponding load is being driven.
Note, however, that the signal for detecting whether it is being driven differs
depending on each load.
Signals marked by a circle are detected.
I/O No. Control signal Drive signal to
in the board the load
SOLA1

SOLA2

SOLA3

SOLA4

MA1

MA2

MA3

MA4

PA1

PA2

PA3

PA4

SVA1

SVA2

SVA3

SVA4

CLA1

CLA2

CR-IR 363 Service Manual
MD-47
I/O No. Control signal Drive signal to
in the board the load
CLA3

CLA4

MB1

MB2

MB3

MC1

MC2

MC3

MC4

MZ2

MZ3

MZ4

MD1

MD2

ME1

ME2

ME3

SOLE1

MD-47