FujiFilm PROFECT CS Service Manual page 992

2.
Set the number of checks.
The IMG board and SNS/DRV board are checked in sequence.
When the checks are completed, the number of checks that has been set
disappears, with the following displayed.
l GOOD indication
l NO GOOD indication
"RESULT: XXXX (XXXX: error code)" is displayed.
NOTE
u u
A four-digit number is displayed as an error code.
Perform the troubleshooting procedure with "1" added to the head of the
displayed error code.
---Example---
When the displayed error code is "0293":
→ Perform the troubleshooting procedures for the error of "10293".
NOTE
u u
In the case of "NO GOOD" indication:
{Troubleshooting}
3.
Exit the MUTL.
{MU:5.2.2_Exiting the MUTL}
4.
Turn OFF the power of the RU and back ON.
011-202-08E
09.30.2009 FM5540
[2-1] All Board
The entire diagnostics for the electrical subsystems are repeated for the number
specified.
The boards to be diagnosed are as follows.
- CPU Board
- IMG Board
- SCN/SCT Board
- SNS/DRV Board
REFERENCE
If the diagnostic results of the board check are normal when the number of checks is
set to "1", twenty-five "RESULT-OK" messages appear.
[2-2] CPU Board
The following diagnostics are repeated for the number specified.
- SDRAM read/write test
- CheckSum (FLASH-ROM/IPL) checksum comparison
- CheckSum (FLASH-ROM/APL) checksum comparison
- CheckSum (FLASH-ROM/APL) read/write test
- Interrupt diagnostics
- Register read/write test
REFERENCE
If the diagnostic results of the board check are normal when the number of checks is
set to "1", six "RESULT-OK" messages appear.
CR-IR 363 Service Manual
MU-59
MU-59