Initial Configuration Using NetVision
Programming Network Information
You can use the following recommended procedure to program the network information into the RocketLinx ES7506.
Note: If you have multiple RocketLinx managed switches that you want to program sequentially, you can use the following
procedure and shift-click to highlight multiple switches. Enter an appropriate IP address range, subnet mask, and
click Apply.
1.
If you have not done so, copy NetVision to a host system. See
2.
Start NetVision.
3.
Click the Discovery button, after five seconds the RocketLinx ES7506 should be listed.
4.
Highlight the RocketLinx ES7506, double-click the IP Address field and enter a desired IP address.
5.
Double-click the Netmask field and enter a desired subnet mask.
6.
Select the IP Settings --> Modify IP menu item to commit the IP address and Netmask change to the RocketLinx ES7506
switch. Optionally, you can right-click and click Change IP.
7.
Click Yes.
Note: Most menu items are available by right-clicking your mouse.Many of these functions can also be done using the Web
configuration GUI or through the command line interface.
14 - RocketLinx ES7506 User Guide: 2000529 Rev. E
Setting Up NetVision
on Page 11 to locate NetVision.
Programming Network Information