Table of Contents
Advertisement
7.4: Upgrade the Submeter Using V-Switch
The Shark® 100S meter is equipped with V-Switch
technology is a virtual firmware-based switch that allows you to enable submeter fea-
tures through communication. This allows the unit to be upgraded after installation to
a higher model without removing the unit from service.
Available V-Switch
V-Switch
key 3 (V-3): Volts, Amps, kW, kVAR, PF, kVA, Freq., kWh, kVAh, kVARh &
TM
DNP 3.0
V-Switch
key 4 (V-4): Volts, Amps, kW, kVAR, PF, kVA, Freq., kWh, kVAh, kVARh,
TM
%THD Monitoring, Limit Exceeded Alarms & DNP.3.0
To obtain a V-Switch
V-Switch
keys are based on the particular serial number of the ordered submeter.
TM
To obtain a higher V-Switch
tion:
• Serial number(s) of the submeter(s) you want to upgrade.
• Desired V-Switch
• Credit Card or Purchase Order Number.
Contact EIG's inside sales staff with the above information at sales@electroind.com or
(516) 334-0870 (USA) and EIG will issue you the Upgrade Code.
To change the V-Switch
1. Install Communicator EXT 3.0 on your computer.
2. Set up the Shark® 100S submeter to communicate with your computer (see
Chapter 5); power up your submeter.
3. Log on to Communicator EXT software.
4. From the Main screen, click Tools>Change V-Switch. You will see the screen
shown on the next page.
Electro Industries/GaugeTech
Electro Industries/GaugeTech
The Leader In Power Monitoring and Smart Grid Solutions
The Leader In Power Monitoring and Smart Grid Solutions
TM
keys
TM
key
key, you need to provide EIG with the following informa-
TM
key upgrade
TM
key:
TM
Doc
7: Using the Submeter
Key Technology
TM
key technology. V-Switch
TM
E145721
#
key
TM
7 - 19
Advertisement
Table of Contents
