Table of Contents
Advertisement
6.2: Using the Front Panel
You can access four modes using the Shark
• Operating Mode (Default)
• Reset Mode
• Configuration Mode
• Information Mode. Information Mode displays a sequence of screens that show model information, such as
Frequency, Amps, V-Switch, etc.
Use the Menu, Enter, Down and Right buttons to navigate through each mode and its related screens.
NOTES:
Appendix A
•
contains the complete Navigation Map for the front panel display modes and their screens.
• The meter can also be configured using software; see the
6.2.1: Understanding Startup and Default Displays
Upon Power Up, the meter displays a sequence of screens:
• Lamp Test Screen where all LEDs are lit
• Lamp Test Screen where all digits are lit
• Firmware Screen showing build number
• Error Screen (if an error exists).
After startup, if auto-scrolling is enabled, the Shark
the front panel. The Kilo or Mega LED lights, showing the scale for the Wh, VARh and VAh readings. Figure 6.3
shows an example of a Wh reading.
®
The Shark
200 meter continues to provide scrolling readings until one of the buttons on the front panel is pressed,
causing the meter to enter one of the other Modes.
e
Electro Industries/Gauge Tech
®
200 meter's front panel buttons:
Communicator EXT User's Manual
®
200 meter scrolls the parameter readings on the right side of
Figure 6.3: Wh Reading
Doc# E149701
for instructions.
6-2
Advertisement
Table of Contents
